Everyday Ten Ask certcollection vce
1. Question: The interface is turned on authentication and it can see the mac address learned on the interface by showing mac before authentication. If the interface's device is authenticated , dose show mac can't see the device?
Answer: This can be resolved by the following command: show dot su
2. Question: Turn off mac address learning on SVI interface
Answer: The mac address learning function cannot be turned off on the SVI interface, the physical port and the global can be turned off.
3. Question: Do i find two mac addresses for the switch?
Answer: The switch has two mac addresses, one is two-tier, the third-tier mac is two-tier mac plus 1 show menber sees the second floor.
4. Question: How do I view my device's mac table usage statistics?
Answer: Use the command: show mac count
5. Question: Will vrrp's virtual gateway mac change?
Answer: There will be no change in the same vrrp group, 00-00-5e-00-01-XX to indicate that the next two bits of XX are represented by the 16-bit corresponding to the group number of the vrrp group. For example: vrrp group number is 23, then its corresponding mac address should be 00-00-5e-00-01-17
6. Question: How to see which access switch is connected under the mac address of ap on the switch?
Answer: At this point, the lookup must be the ap normal power, normal operation, and then according to the known ap mac address-1 and look on the switch. The mac viewed on the ap and the mac on the switch view -1 and the mac on the ac view of the mac and 1 s the mac viewed on the switch.
7. Question: Ping test found that the packet was lost but it also regularly dropped the bag.
Answer: It can be said that the cPP protection mechanism bandwidth settingist is increased to confirm whether it is caused by the CPP protection mechanism of the drop package.
8. Question: How do I clear the packet information of the CPP?
Answer: Restart your device or use the clear cpu-protect counter.
9. Question: How is the mtu value modified under the two-tier port?
Answer: Go directly to the interface to modify it.
10. Question: How does the switch configure jumbo frames?
Answer: Switch configuration jumbo frameis is the interface to configure mtu to the maximum.
PASSHOT will often update some network engineers in the work of the difficult problems. If you feel good, please collect our website! Here can help you CCIE Written exam and CCIE Lab exam.
Comments
Post a Comment