Everyday Ten Ask CCIE R&S VRRP ccie 400-101 lab dumps

1. Question: Set up two core devices of VRRP. The spanning tree elects itself as root.

Answer: In the MSTP network, the vlan associated with the spanning tree instance of the entire network must be consistent. Otherwise, the root election will be confused.
2. Question: Does Cisco's switch support Load balancing?
Answer: Support.
3. Question: How does VRRP achieve load balancing?
Answer: There are two ways:
(1) Configure the gateway IP address of the terminal to configure the gateway IP of the active and standby devices respectively. The terminal determines whether the traffic is forwarded by the primary device or forwarded by the standby device.
(2) With VRRP plus, hosts on the LAN use a unified gateway IP but when different hosts request gateway ARP, VRRP plus responds to different virtual MACs . Thereby distributing traffic from different hosts to VRRP. Load balancing is achieved on different members of Plus.
4. Question: Can the physical address participate in the communication after the switch has done VRRP?
Answer: Yes, VRRP only does the gateway address redundancy and does not change the original physical network structure. The physical address and the actual link. Used in normal use.
5. Question: Which port types can the VRRP track monitor?
Answer: The monitored interface is only allowed to be a logical interface of Layer 3 routing. For example: routed port, SVI, loopback, tunnel
6. Question: What is the default interval for BPDU messages in RSTP mode?
Answer: 2 seconds
7. Question: How is static routing load balanced?
Answer: If multiple static routes are configured on the device at the same time, the destination address mask is the same. Then, the packets are sent from the device. The load balancing is the same as that of the aggregation port. The adjustment method is the same.
8. Question: Does the switch support dial-up access?
Answer: The switch does not support ppoe dialing that only routing devices support it.
9. Question: Between ospf and rip, the default route redistribution will not take effect. For example, the default route of OE1 wants to be redistributed into rip. This is not possible.
Answer: Solution:
      On the rip, the default route is delivered:
      Cisco(config)#router rip
      Cisco(config-router)#default-information originate Always
10. Question: Why is there no error after configuring the static route but the show run is not displayed and the show ip route can not see the route?
Answer: Check if the device is configured with no ip routing
PASSHOT will often update some network engineers in the work of the difficult problems. If you feel good, please collect our website! Here can help you CCIE Written exam and CCIE Lab exam.  

Comments

Post a Comment

Popular posts from this blog

How to choose Cisco dumps?

Image
In this era of lack of trust between people, if you want to buy one thing, in addition to buying on a platform such as a regular platform, such as Amazon. Do you still believe in other self-built platforms? I believe many people have the experience of being cheated. lowest The means of defrauding money is: Your good friend comes to borrow money from you, and you have a relationship card with you so that you can lend him money. At this time, according to the normal person’s thinking, this friend has known me for many years that he might not take the money away. Note that it is often the same idea that gives others the opportunity to owe money. If the amount borrowed is not high, then it is okay. Once the amount you borrowed is too large, you should be careful and your money may not be returned! Back to the topic, in this era of lack of trust, how to choose the Cisco dumps have become an important topic. First, when you buy it depends on whether the website's URL link is https
Read more

What is proxy communication?

Image
Is it correct to understand the working level of forward proxy reverse proxy transparent proxy? Forward proxy and reverse proxy (application load balancing, some NG reverse proxy) can be understood as a man-in-the-middle mode. At the same time, both ends establish a TCP connection, and then the man-in-the-middle performs TCP connection between the two ends. Can a transparent proxy be understood as a simple and crude "hijacking" of a passing data packet, without splitting the complete TCP connection into two independent segments. So, in this sense, this kind of transparent proxy is similar to the working hierarchy of NAT devices? Preface I once saw a person write tens of thousands of words to answer a question, and read it after three days. Shocked, what is all this for? These words can produce a book, and it is also a reward for your hard work. However, I think the man has always been happy, but there is no doubt that his reputation (Reputation) is in full swin
Read more

What are CCNP Data Center jobs in Dubai?

Image
  What are CCNP Data Center jobs in Dubai? Over the last few years, Cisco accreditations have gotten popular astonishingly. Undoubtedly, Cisco certifications would be deemed the outright most necessary certificates in the field of computer system networking. About Cisco certifications, there would be an extensive range of choices. To help your career and assist you in opening brand-new doors in your career, you need the ideal accreditations. Cisco introduced its primary certification program in 1998. The essential idea behind the accreditations was to supplement the CCIE or Cisco Certified Internetwork Expert program. Cisco would have extended its qualifications and supplies lots of certifications for experts of all experience levels from that point forward. CCNP Overview: CCNP or Cisco Certified Network Professional is considered the certification available for IT specialists with one year of expert experience in computer system networking. A diploma or equivalent in a significant fie
Read more