PASSHOT Let You Pass The CCIE R&S Exam Easily ccie r&s lab topology
"You can't change the environment, but you can change yourself." This is the deepest feeling in the process of learning CCIE. Learning CCIE is definitely very difficult. If you choose to study, you can't complain and change yourself to adapt to learning. You will be able to pass the ccie r&s written exam and ccie r&s lab exam!
TS2
1. SW410 has Port Security, change PC MAC address, port shutdown, no shut appears.
2. R14 has traffic blocking the server, and ACL no 10 appears.
3. R10 has called Route-map, set local-pre 1000 changed to 100, R22 interface lo0 OSPF announces an error, and the two places appear after correction.
4. R20 has a call to Route-map, and the set extcommunity cost pre-bestpath can be removed.
5. R60 crypto ipsce transform-set verification is not the same, refer to R51 settings.
6. SW111 Int vlan2001 does not apply IPv6 dhcp server
7. R3 mpls ldp neighbor 100.0.0.3 password cisc0 password error, changed to cisco
8. The R30 Default-router setting is reversed and can be corrected.
9. R24 is less ip nhrp map multicast dynamic
10. R24 fills in Ip nat outside source static 201.99.70.2 201.99.25.70, R25 BGP declaration mask has problem 252, change 255.
(At the beginning of the tra server, R24, after the R25 mask is corrected, the tra server path goes back to R25, and the same can occur.)
D2
Look at the R3 log "show ip pim rp map" without RP Source ip 0.0.0.0 to determine D2
Icmpv6.type==134 capture packets, remember that the first one has FE80::666 is 193
LAB3:
1. First add the second layer interface Sw mo acc
2. SW510 Pay attention to the table and pay attention to distinguish between Po 2 e 2/0 2/1 Po 1 e 2/2 e2/3
3. SW300/301 Note to be spanning-tree mst simulate pvst global
4. OSPF and BGP area provisioning without router-id must be filled in (I have not filled in some parts, and later discovered that the test phenomenon is completely different, after softening is normal)
5. 3.3 There is one more requirement, so that R60 does not send useless ARP information to the SP.
6. 4.1 More than one IPv6 requirement, the Hop hop count cannot exceed 2
Finally, thanks to the PASSHOT lecturer, this is really a very good institution, highly recommended! The teachers are very careful. When I have a problem, I can always reply to me in time, thank you!
Comments
Post a Comment